How to remove the headlight adjuster of the car

How to disassemble the headlight assembly adjuster: The motor is fixed in position, first unscrew the motor and loosen it, then remove the screw and the motor can be taken out. If the motor is not fixed in the card position, it is best to go to the 4S shop to disassemble it, so as to avoid damage during the disassembly process. The dismantling method of modern leading headlights is as follows: 1. Unplug the power socket of the bulb, turn off the flame for more than 5 minutes, remove the car key, wait for the engine to cool down completely, and then open the engine compartment cover; 2. After opening the engine compartment cover, you can When you see the dust cover behind the headlight assembly, the dust cover is mostly made 3. After removing the dust cover, you can see the light bulb in the headlight assembly The base, pinch the wire clip next to the base, and after the clip is released, you can take out the light bu lb. Hyundai Leading is the earlier Langdong, I want to change the headlight adjuster, but I don't know how to remove the headlight adjustment motor: the motor is fixed in position, first unscrew the motor to loosen it, then remove the screw and the motor can be taken come out. If the motor is not fixed in the card position, it is best to go to the 4S shop to disassemble it, so as to avoid damage during the disassembly process. The solutions for the broken headlight height adjusters are as follows: 1. The headlight adjuster can be repaired if it is broken, but the masters of the 4S shop will recommend replacing the assembly. It is very simple to replace the parts directly; 2. Under the influence of the load of the trunk, long-term vibration, high and low road conditions, etc., the headlights of the car will cause the irradiation direction to deviate from the standard direction. The function of the light adjuster is to adjust the headlight irradiation. The direction is restored from the d eviation direction to the standard direction, thereby improving the lighting effect of the headlight; 3. At present, the light adjuster mainly has two modes: manual and automatic: the manual mode is mainly composed of a headlight adjustment motor and a manual switch, and the headlight adjustment motor is in the At the front light, the control part is in the cab, and there is a manual switch on the instrument panel, which can be adjusted by the driver according to his own needs; 4. The automatic type is composed of a headlight adjustment motor, a controller and two level sensors. The level sensors are respectively Installed at the front and rear ends of the car body, it mainly detects the height of the car chassis to the ground, and transmits the height difference to the controller in the form of electrical signals. The controller controls the headlight adjustment motor after comparison and calculation, so as to complete the automatic adjustment of the headlight Function.